How do I install electric fire exit signs into my emergency lighting units?
lamontnow asked:
I have an emergency lighting unit on each floor of my building. The problem is that the boxes have no exit sign. Can I remove the cover and replace it with an exit sign? Would it fit? Are the boxes and signs standard sizes? If so I would buy the signs at home depot and have an electrician install them.
I have an emergency lighting unit on each floor of my building. The problem is that the boxes have no exit sign. Can I remove the cover and replace it with an exit sign? Would it fit? Are the boxes and signs standard sizes? If so I would buy the signs at home depot and have an electrician install them.
Possibly Related Posts:
- Is a broken light switch where the light stays on dangerous?
- Can one light bulb in a series of eight recessed lights cause a dimmer switch to stop working?
- Why does my recessed light continually turn on and off on it’s own?
- What would cause a light fixture to be brighter at times and noticeably not as bright other times?
- I want to learn how to do basic electrical wiring and lighting in my home. What’s a good resource?
Fire code states that the exit signs (red or green) be installed and lit over each fire exit door or hall way leading to an exit. They have to be illuminated in dark areas and night time during store hours. I usually wire the exits to remain on 24/7 wether occupied or not. Some exit sign are also battery back up in case of power failure They are wired separate from emergency lights. Emergency lights are battery operated and when fully charged will illuminate the area needed for about an hour during a power failure. They will come on during the day time if there is a power failure unless they have a photo electric sensor. Emergency lights cost about $35.00 and can be hard wired or plugged into an outlet. Check with electrical or fire codes as to which one is admissible. Emergency light have to wired into circuits that are on 24/7 as they operate on power failures. Exit signs are manufactured different than the lights. They are not that expensive for what they do All items needed are available at the Depot [who] Bill
The Manufacturer of the Unit can probably provide
a bolt-on exit sign package.
You might have a problem with that as the Code requires a specific battery capacity, (operating time),
for such fixtures and the addition of another load might
shorten that time below limits for the new installation.
A possible solution is phosphorescent exit signs. [who] Irv S